This is a 3D printed enclosure for the larger LightBurn 8MP cameras, based on an original design by Neil Rosenberg.

Ours has been designed to fit the larger 8MP cameras we sell (85 and 120 degree), and includes a small interior lip to prevent the camera from sliding. The mount is made to attach to the inside of the lid with 3M double-sided VHB tape. The camera angle is easily adjusted by loosening the knobs on either side of the mount, and the face plate is held in place by tension clips.

For assembly, you'll need two m5x15 screws and two m5 nuts, as well as strong mounting tape (we recommend 3M double-sided VHB tape) for mounting to the lid.

You can find the original at https://www.thingiverse.com/thing:3891092 or https://www.printables.com/model/439724-lightburn-camera-mount